德國Femto超低噪聲電流放大器LCA-2-10T
價 格：詢價
產 地：德國更新時間：2020-10-29 17:28
品 牌：Femto型 號：LCA-2-10T
狀 態：正常點擊量：2492
400-006-7520
聯系我時，請說明是在上海非利加實業有限公司上看到的，謝謝！
聯 系 人：
上海非利加實業有限公司
電 話：
400-006-7520
傳 真：
400-006-7520
配送方式：
上海自提或三方快遞
聯系我時請說在上海非利加實業有限公司上看到的,謝謝！
High Gain for Low Noise Performance
In order to attain an extremely low noise performance very high gains were chosen for the LCA-2-10T amplifier. A real transimpedance gain of 1012 V/A enables the extraordinary low input noise current of 0.18 fA/√Hz. An additional amplifier stage with a variable voltage gain of x1 and x10 was added to offer greater flexibility for varying applications and signal amplitudes. Like this an unparalleled sensitivity is achieved allowing real-time current measurements from 1 fA up to 10 pA without the need for further signal averaging.
產品參數
Extremely Low Input Noise Current of 0.18 fA/√Hz
Variable Gain 1012 V/A and 1013 V/A
Variable Low Pass Filter 2 Hz, 0.3 Hz and 0.1 Hz
Optimized for DC Measurements
產品介紹
Bandwidth and Frequency Response
Naturally, high gain amplifiers cannot achieve the speed of models with low gain. Due to the special FEMTO amplifier design measurements of extremely low currents can be performed with the LCA-2-10T in real-time. Signal changes can be monitored with a rise time down to 200 ms. For applications where response time is of lower importance the built-in signal filters can be used to further improve the sensitivity and noise performance of the measurement setup. Three filter settings allow adaptation to many different signals and measurement tasks.
Applications
Sensitive Current and Charge Measurements
Spectroscopy
Scanning Microscopy of Very High Impedance Samples (STM, conductive AFM)
Photodiode Amplifier
Characterization of Electronic Components
Preamplifier for Oscilloscopes, A/D Converters, Digital Voltmeters etc.
滬公網安備31011502016460號
